Hydraulic SystemThe Hydraulic System serves the Spindle Tool Clamping Device, the A-Axis Clamping Brake, the B-Axis Clamping Brake, the Workpiece Clamping Fixture, and the Workpiece Clamping/Unclamping Devices. The 160 L (hydraulic oil ISO-L-HM 46) hydraulic reservoir has a breather (venting) filter, a level switch, a return pressure switch, and a temperature sensor. The breather filter filler cap is a 10 micron filter which allows air to pass between the inside of the reservoir and the environment without contamination. This ensures no pressure will build up in the reservoir while the system is running. The float switch is a two (2) setting switch that has a pre-warning low level and a shut down low level. This will ensure that if the level goes too low, the machine will not be able to run until the reservoir is correctly refilled. The temperature switch is also a (2) setting switch with a pre-warning and shut off setting. This will ensure that the machine cannot run if the hydraulic fluid is too hot. A pressure switch monitors the outgoing hydraulic fluid pressure to the machine. TThere is a low and high power Pressure that is 80 bar and 200 bar respectively which draws fluid from the reservoir and sends it through three (5) separate branches. Each branch serves a device or set of devices and is shown with their respective devices listed below:
All return lines lead back to the hydraulic filter where any contaminants picked up in the system will be filtered out of the fluid through a 10 micron filter unit equipped with a clogged filter pressure switch. The cleaned fluid is then returned to the hydraulic reservoir. Hydraulic System ComponentsTo view individual components of the hydraulic system, click the "Hydraulic System Components" button below. To view controls drawings on the hydraulic system, click the "Hydraulic Controls Drawings" button below. H10000 Direct LoadHydraulic System Components Hydraulic Controls DrawingsH10000 A-AxisHydraulic System Components Hydraulic Controls DrawingsH10000 Pallet ChangerHydraulic System Components Hydraulic Controls Drawings |